系统仿真学报 ›› 2016, Vol. 28 ›› Issue (7): 1673-1679.

• 仿真应用工程 • 上一篇    下一篇

开关用BJT的特性研究和PSPICE仿真

李孜, 张渊博   

  1. 上海理工大学,上海 200093
  • 收稿日期:2015-04-02 修回日期:2015-09-10 出版日期:2016-07-08 发布日期:2020-06-04
  • 作者简介:李孜(1972-),女,河北邢台,博士,副教授,研究方向为脉冲功率的发生及应用;张渊博(1991-),女,江苏南通,硕士,研究方向为脉冲功率的发生及应用。
  • 基金资助:
    上海市科技英才扬帆计划(15FYI1408300)

Switching Characteristics of BJT and PSPICE Simulation

Li Zi, Zhang Yuanbo   

  1. University of Shanghai for Science and Technology, Shanghai 200093, China
  • Received:2015-04-02 Revised:2015-09-10 Online:2016-07-08 Published:2020-06-04

摘要: 在Marx脉冲功率发生器中,开关是最重要的组件,其特性直接影响输出脉冲上升沿。提出一种利用BJT(Bipolar Junction Transistor)集电极与发射极间的雪崩击穿特性的新型开关器件代替传统开关的方法,可实现Marx输出上升沿小于5ns的脉冲电压,可代替传统Marx发生器中的气体开关。介绍不同型号的BJT集电极与发射极间雪崩击穿特性,根据实验结果,以适合小型Marx发生器的BJT开关特性为主要依据选用合适的BJT。目前没有雪崩击穿的仿真元件,只能用PSPICE建立BJT的集电极与发射极间击穿仿真模型代替实际BJT的雪崩击穿,并以此来辅助Marx脉冲发生器的设计。

关键词: BJT, 雪崩击穿, PSPICE仿真, Marx发生器

Abstract: In Marx type pulsed power devices, the switch is the most important component to determine the rising time of output pulses. A novel switching device utilizing the avalanche breakdown characteristic between the collector and emitter of BJT,was proposed to replace the traditional switch. Impules voltage could be outputted in less than 5ns by Marx circuit using BJT which could be the alternative switch of general Marx generator. Different BJTs' avalanche breakdown characteristics between the collector and emitter were introduced, according to experimental results, some appropriate BJTs were chosen to be used in Marx generator. At present there is no simulation of the avalanche breakdown, and a simulation model about the avalanche breakdown between the collector and emitter of BJT is built utilizing PSPICE and is applied to assist the designing of Marx generator.

Key words: Bipolar Junction Transistor, avalanche breakdown, PSPICE simulation, Marx generator

中图分类号: