汽轮机主汽阀活动试验建模分析与控制优化

doi:10.16182/j.issn1004731x.joss.201710039

系统仿真学报 ›› 2017, Vol. 29 ›› Issue (10): 2542-2549.doi: 10.16182/j.issn1004731x.joss.201710039

汽轮机主汽阀活动试验建模分析与控制优化

盛锴, 彭双剑, 寻新, 王伯春, 傅强

国网湖南省电力公司电力科学研究院,湖南长沙 410007

收稿日期:2015-10-10 发布日期:2020-06-04
作者简介:盛锴(1983-),男,湖南长沙,硕士,高工,研究方向为网源协调控制;彭双剑(1984-),男,湖南祁东,博士,高工,研究方向为热工自动优化;寻新(1969-),男,湖南长沙,硕士,高工,研究方向为热工自动控制优化。

Modeling of Steam Turbine's Governing System During Main Steam Valve Activity Test and Control Optimization

Sheng Kai, Peng Shuangjian, Xun Xin, Wang Bochun, Fu Qiang

State Grid Hunan Electric Power Corporation Research Institute, Changsha 410007, China

Received:2015-10-10 Published:2020-06-04

摘要/Abstract

摘要： 针对某300 MW机组汽轮机主汽阀活动试验负荷波动剧烈的问题,建立了主汽阀活动试验时的汽轮机调节系统模型,该模型由包含主汽阀活动试验逻辑的电液调节系统模型、调节汽阀模型和考虑调节汽阀流量特性的汽轮机模型组成。依据模型分析了主汽阀活动试验时负荷剧烈波动的原因,指出引起负荷波动的主要原因是控制方式、DEH(Digital Electric Hydraulic Control System)设置、机组特性的不匹配,通过仿真试验研究了解决该问题的控制优化方法,基于此方法指导实际机组的主汽阀活动试验。试验结果表明,经控制优化后主汽阀活动试验引起的负荷波动问题得到显著改善。

关键词: 主汽阀活动试验, 负荷波动, 汽轮机调节系统, 控制优化

Abstract: A Model of 300 MW thermal power unit's governing system of steam turbine is established to analyze its load fluctuation during main steam valve activity test. The model contains three sub-models; they are the model of turbine's governor during main steam valve activity test, the model of electric-hydraulic servo actuator, and the model of turbine considering governing valve's discharge characteristic. The analyses on these models indicate that mismatch among control model, configuration of DEH (Digital Electric Hydraulic Control System) and characteristic of the unit is the cause of load fluctuation. Through simulation, the method for load fluctuation suppression was determined. Result of actual main steam valve activity test based on the method shows that load fluctuation is obviously suppressed after control optimization.

Key words: main steam valve activity test, load fluctuation, governing system of steam turbine, control optimization

中图分类号:

TP391.9

盛锴, 彭双剑, 寻新, 王伯春, 傅强. 汽轮机主汽阀活动试验建模分析与控制优化[J]. 系统仿真学报, 2017, 29(10): 2542-2549.

Sheng Kai, Peng Shuangjian, Xun Xin, Wang Bochun, Fu Qiang. Modeling of Steam Turbine's Governing System During Main Steam Valve Activity Test and Control Optimization[J]. Journal of System Simulation, 2017, 29(10): 2542-2549.

参考文献

[1] 夏维. 600 MW超临界汽轮机高压主汽门-调节汽门单边联合阀门活动试验综合优化措施[J]. 广东电力, 2014, 27(5): 23-27.
(Xia Wei.Comprehensive optimization measures for unilateral joint valve activity test of high pressure total valve-governing valve of 600MW supercritical steam turbine[J]. Guangdong electric power, 2014, 27(5): 23-27.)
[2] 孙伟东. 600 MW汽轮机全自动阀门活动试验方法[J]. 华北电力技术, 2010(11): 13-15.
(Sun Weidong.Testing method of auto-valve of 600MW steam turbine[J]. North china electric power, 2010(11): 13-15.)
[3] DL/T 774-2015 火力发电厂热工自动化系统检修运行维护规程[S].(DL/T 774-2015 Overhaul & operate of thermodynamic automatic system in fossil fuel power plant [S].)
[4] DL/T 656-2006 火力发电厂汽轮机控制系统验收测试规程[S].
(DL/T 656-2006 Code for acceptance test of turbine control system in fossil fuel power plant [S].)
[5] 盛锴, 刘复平, 刘武林, 等. 汽轮机阀门流量特性对电力系统的影响及其控制策略[J]. 电力系统自动化, 2012, 36(7): 104-108.
(Sheng Kai, Liu Fuping, Liu Wulin, et al.Influence of steam turbine valve discharge characteristics on power systems and its control strategy[J]. Automation of Electric Power Systems, 2012, 36(7): 104-108.)
[6] 盛锴. 基于内模控制的火电机组功率控制系统[J]. 热能动力工程, 2013, 28(6): 616-621.
(Sheng Kai. Power control system for thermal power generator units based on the inner model control [J]. Journal of Engineering for Thermal Energy & Power, 2013, 28(6): 616-621.)
[7] 盛锴, 魏乐, 江效龙, 等. 基于PSASP和Simulink的汽轮机调节系统建模与仿真校核[J]. 中国电力, 2015, 48(2): 1-6.
(Sheng Kai, Wei Le, Jiang Xiaolong, et al.Modeling, simulation and verification of turbine governing system based on PSASP and Simulink[J]. Electric Power, 2015, 48(2): 1-6.)
[8] 盛锴, 朱晓星, 倪宏伟, 等. 汽轮机调节系统模型仿真校核技术[J]. 中国电力, 2013, 46(12): 52-58.
(Sheng Kai, Zhu Xiaoxing, Ni Hongwei, et al.Simulation and model validation of steam turbine and its governing system[J]. Electric Power, 2013, 46(12): 52-58.)
[9] 盛锴. 高压汽室蒸汽容积环节模型参数对再热凝汽式汽轮机调速系统仿真校核的影响[J]. 华东电力, 2012, 40(11): 2049-2053.
(Sheng Kai.Influence of high pressure cylinder steam volume link model parameters on the speed governing system simulation and calibration for reheat condensing turbine[J]. East China Electric Power, 2012, 40(11): 2049-2053.)
[10] 朱晓星, 盛锴, 刘陆军. 基于综合算法的汽轮机及其调节系统参数智能辨识[J]. 电力系统保护与控制, 2013, 41(20): 138-143.
(Zhu Xiaoxing, Sheng Kai, Liu Lujun.Intelligent parameter identification of steam turbine and its governing systems based on multi-algorithm[J]. Power System Protection and Control, 2013, 41(20): 138-143.)
[11] 田云峰, 郭嘉阳, 刘永奇, 等. 用于电网稳定性计算的再热凝汽式汽轮机数学模型[J]. 电网技术, 2007, 31(5): 39-44.
(Tian Yunfeng, Guo Jiayang, Liu Yongqi, et al.A mathematical model of reheat turbine for power grid stability calculation[J]. Power System Technology, 2007, 31(5): 39-44.)
[12] 李劲柏, 刘复平. 汽轮机阀门流量特性函数优化和对机组安全性经济性的影响[J]. 中国电力, 2008, 41(12): 50-53.
(Li Jinbai, Liu Fuping.Optimization for the flow characteristic function of turbine valves and the influences on safe and economic operation[J]. Electric Power, 2008, 41(12): 50-53.)
[13] DL/T1235-2013 同步发电机原动机及其调节系统参数实测与建模导则[S].
(DL/T 1235-2013 Guide for modeling and testing of generator prime mover and governing system [S].)

汽轮机主汽阀活动试验建模分析与控制优化

Modeling of Steam Turbine's Governing System During Main Steam Valve Activity Test and Control Optimization

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 1

编辑推荐

Metrics

本文评价