考虑串件拼修的k/N系统批量备件配置方法

doi:10.16182/j.issn1004731x.joss.201703025

系统仿真学报 ›› 2017, Vol. 29 ›› Issue (3): 654-661.doi: 10.16182/j.issn1004731x.joss.201703025

考虑串件拼修的k/N系统批量备件配置方法

王永攀^1,2, 常春贺², 杨江平²

1.93502部队,内蒙古呼和浩特 010051;
2.空军预警学院,湖北武汉 430019

收稿日期:2015-05-29 修回日期:2015-09-06 出版日期:2017-03-08 发布日期:2020-06-02
作者简介:王永攀(1987-),男,河北保定,博士,研究方向为预警装备管理与保障;常春贺(1982-),男,河南上蔡,博士,研究方向为雷达装备管理与维修保障技术。
基金资助:
军内科研项目(KJ2014023200B11145), 博士研究生专项课题(2014JY546)

Optimal Configuration Method of Block Spare Parts for k/N Systems Considering Cannibalization

Wang Yongpan^1,2, Chang Chunhe², Yang Jiangping²

1. Unit 93502 of PLA, Hohhot 010051, China;
2. Air Force Early Warning Academy, Wuhan 430019, China

Received:2015-05-29 Revised:2015-09-06 Online:2017-03-08 Published:2020-06-02

摘要/Abstract

摘要： 针对k/N系统批量备件的配置问题,提出一种视情维修条件下考虑串件拼修的备件优化配置方法。建立了基于串拼修复率和SRU更换率的系统级备件满足率模型,给出了串拼修复率和SRU更换率的约束条件。以备件配置费用最小为目标、以系统备件满足率为约束条件建立了系统备件的优化配置模型,设计了一种基于边际效益分析法的模型求解算法。以某型大型相控阵天线阵面备件配置为例,利用定量和比较的仿真分析方法对提出的模型进行了验证,得到了备件的优化配置结果。结果表明：提出的模型真实有效、可行性强,为进一步研究k/N系统批量备件的配置问题提供了理论支持。

关键词: k/N系统, 批量备件, 串件拼修, 备件配置, 备件满足率

Abstract: Aiming at the configuration problem of block spare parts in k/N systems, an optimal configuration method of block spare parts considering cannibalization and on-condition maintenance was proposed. A spare parts fill rate model for k/N systems was established on the basis of two parameters named cannibalization rate and SRU replacement rate, and the constraint conditions of both the parameters were given respectively. An optimal configuration model was built, which chose the minimum spare costs as the object and the spare fill rate as the subject, and a model solution algorithm based on the margin analysis theory was given. Simulations and analysis were conducted by taking the spare parts configuration problem of one large-scale phased array antenna as an instance, and the optimal results were achieved through the simulation methods of quantitative and comparative analysis. The results show that the presented model is of high validity and feasibility, and can provide theoretical support for the deeply research on the block spare parts configuration problems for k/N systems.

Key words: k/Nsystems, block spare parts, spare parts configuration, cannibalization, spare parts fill rate

中图分类号:

N94/N95

王永攀, 常春贺, 杨江平. 考虑串件拼修的k/N系统批量备件配置方法[J]. 系统仿真学报, 2017, 29(3): 654-661.

Wang Yongpan, Chang Chunhe, Yang Jiangping. Optimal Configuration Method of Block Spare Parts for k/N Systems Considering Cannibalization[J]. Journal of System Simulation, 2017, 29(3): 654-661.

参考文献

[1] 王永攀, 杨江平, 郑玉军, 等. 任意备件条件下的k/N系统维修优化模型[J]. 解放军理工大学学报(自然科学版), 2015, 16(6): 569-574.
(Wang Y P, Yang J P, Zheng Y J, et al.Optimal Maintenance Model for the k-out-of-n System with random spares[J]. Journal of PLA University of Science and Technology Natural Science Edition, 2015, 16(6): 569-574.)
[2] 卢雷, 杨江平. 任意寿命分布下k/N(G)系统定时维修决策模型[J]. 现代防御技术, 2015, 43(1): 145-149.
(Lu L, Yang J P.Time based maintenance optimization model for k/N (G) system with various lifetime distribution[J]. Modern Defence Technology, 2015, 43(1): 145-149.)
[3] 卢雷, 杨江平. k/N(G)结构系统初始备件配置方法[J].航空学报, 2014, 35(3): 773-779.
(Lu L, Yang J P.Initial spare allocation method for k/N(G) structure system[J]. Acta Aeronautica Sinica, 2014, 35(3):773-779.)
[4] 聂涛, 盛文. K:N系统可修复备件两级供应保障优化研究[J]. 系统工程与电子技术, 2010, 32(7): 1452-1455.
(Nie T, Sheng W.Research on two-echeon supply support optimizing for repairable spare parts of K:N system[J]. Systems Engineering and Electronics, 2010, 32(7): 1452-1455.)
[5] 薛陶, 冯蕴雯, 秦强. 考虑报废的K/N系统冷备份冗余系统可修复备件优化[J]. 华南理工大学学报(自然科学版), 2014, 42(1): 41-46.
(Xue T, Feng Y W, Qin Q.Optimization of repairable spare parts for K/N cold-standby redundant system considering scraps[J]. Journal of South China University of Technology (Natural Science Edition), 2014, 42(1): 41-46.)
[6] 贾治宇, 王立超, 王乃超, 等. 基于停机时间的复杂系统维修资源配置模型[J]. 计算机集成制造系统, 2010, 16(10): 2211-2216.
(Jia Z Y, Wang L C, Wang N C, et al.Maintenance resources configuration model for complex system based on down time[J]. Computer Integrated Manufacturing Systems, 2010, 16(10): 2211-2216.)
[7] 阮旻智, 李庆民, 彭英武, 等. 任意结构系统的备件满足率模型及其优化方法[J]. 系统工程与电子技术, 2011, 33(8): 1799-1803.
(Ruan M Z, Li Q M, Peng Y W, et al.Model of spare part fill rate for systems of various structures and optimization method[J]. Systems Engineering and Electronics, 2011, 33(8): 1799-1803.)
[8] 阮旻智, 李庆民, 彭英武, 等. 串件拼修对策下多级维修供应的装备系统可用度评估[J]. 航空学报, 2012, 33(4): 658-665.
(Ruan M Z, Li Q M, Peng Y W, et al.Evaluation of equipment system availability for multi-echelon maintenance supply with cannibalization[J]. Acta Aeronautica et Astronautica Sinica, 2012, 33(4): 658-665.)
[9] 罗祎, 阮旻智, 李庆民. 任意结构下可修复备件的配置方案优化[J]. 系统工程与电子技术, 2012, 34(9): 1865-1871.
(Luo Yi, Ruan Minzhi, Li Qingmin.Configuration project optimization for repairable spare parts under discretional structures[J]. Systems Engineering and Electronics, 2012, 34(9): 1865-1871.)
[10] 国防科学技术工业委员会. GJB 4335-2002备件供应规划要求 [S]. 北京: 国防工业出版社, 2002.
(Commission of Science and Technology Industry for National Defense. GJB 4355-2002 Spare provisioning requirements [S]. Beijing, China: National Defense Industry Press, 2002.)

考虑串件拼修的k/N系统批量备件配置方法

Optimal Configuration Method of Block Spare Parts for k/N Systems Considering Cannibalization

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价