[1] Winkel O.New Developments in Gear Hobbing[J]. Gear Technology (S0743-6858), 2010(3/4): 45-52. [2] Bouzakis K D, Lili E, Michailidis N, et al. Manufacturing of cylindrical gears by generating cutting processes: A critical synthesis of analysis methods[J]. CIRP Annals-Manufacturing Technology (S0007-8506), 2008, 57(2): 676-696. [3] Antoniadis A, Vidakis N, Bilalis N.Fatigue fracture investigation of cemented carbide tools in gear hobbing, part 1: FEM modeling of fly hobbing and computational interpretation of experimental results[J]. Journal of manufacturing science and engineering (S1087-1357), 2002, 124(4): 784-791. [4] Antoniadis A, Vidakis N, Bilalis N.Fatigue fracture investigation of cemented carbide tools in gear hobbing, Part 2: The effect of cutting parameters on the level of tool stresses: A quantitative parametric analysis[J]. Journal of Manufacturing Science and Engineering (S1087-1357), 2002, 124(4): 792-798. [5] Bouzakis K D.Konzept und technologische Grundlagen zur automatisierten Erstellung optimaler Bearbeitungsdaten beim Wälzfräsen[M]. Düsseldorf, Deutschland: VDI-Verlag, 1981. [6] Gutmann P.Zerspankraftberechnung beim Walzfrasen [D]. Aachen, Deutschland: RWTH Aachen University, 1988. [7] Abood A M.Dynamic analysis of the cutting forces in gear hobbing [D]. Newcastle upon Tyne, UK: Newcastle University, 2003. [8] Vedmar L.A Parametric Analysis of the Gear Surface Roughness after Hobbing[J]. Journal of Mechanical Design (S1050-0472), 2010, 132(11): 1-8. [9] Vedmar L, Andersson C, Stahl J E.A parametric analysis of the undeformed chip geometry in gear hobbing[J]. Journal of manufacturing science and engineering (S1087-1357), 2009, 131(061003): 1-8. [10] Vasilis D, Nectarios V, Aristomenis A.Advanced computer aided design simulation of gear hobbing by means of three-dimensional kinematics modeling[J]. Transactions-American Society of Mechanical Engineers Journal of Manufacturing Science and Engineering (S1087-1357), 2007, 129(5): 911-918. [11] Dimitriou V, Antoniadis A.CAD-based simulation of the hobbing process for the manufacturing of spur and helical gears[J]. The International Journal of Advanced Manufacturing Technology (S0268-3768), 2009, 41(3/4): 347-357. [12] 蒲太平, 唐进元. 基于CATIAV5 的圆柱齿轮虚拟加工研究[J]. 系统仿真学报, 2008, 20(16): 4339-4343. [13] 汪中厚, 李刚, 张兴林, 等. 渐开线斜齿轮整体虚拟滚齿仿真及齿面精度研究[J]. 机械传动, 2012, 36(8): 9-13. [14] Piegl L A, Tiller W.The NURBS book[M]. Germany: Springer, 1997. |