系统仿真学报 ›› 2015, Vol. 27 ›› Issue (12): 3102-3108.

• 短文 • 上一篇    下一篇

薄煤层采煤机滚筒载荷特性仿真分析

赵丽娟1, 田震1, 刘旭南1, 谢波2   

  1. 1.辽宁工程技术大学机械工程学院,辽宁 阜新 123000;
    2.兖州煤业公司综机管理中心,山东 邹城 273500
  • 收稿日期:2014-07-18 修回日期:2015-04-24 出版日期:2015-12-08 发布日期:2020-07-30
  • 作者简介:赵丽娟(1964-),女,辽宁阜新,博士,教授、博导,研究方向为机械系统动力学分析与控制、复杂机电系统建模与仿真、机电液系统仿真与应用;田震(1987-),男,安徽界首,博士生,研究方向为机械系统动力学分析与控制。

Simulation Analysis of Load Characteristic of Thin Seam Shearer Drum

Zhao Lijuan1, Tian Zhen1, Liu Xunan1, Xie Bo2   

  1. 1. College of Mechanical Engineering, Liaoning Technical University, Fuxin 123000, China;
    2. Machinery Management Center, Yanzhou Coal Mining Company Limited, Zoucheng 273500, China
  • Received:2014-07-18 Revised:2015-04-24 Online:2015-12-08 Published:2020-07-30

摘要: 为研究复杂煤层赋存条件下薄煤层采煤机滚筒的载荷特性,根据煤层赋存条件与采煤机工作状态,提出了截齿工作状态的判定条件,并设计出了不同工况下滚筒载荷仿真方案。以某薄煤层采煤机滚筒为研究对象,仿真得到五种典型工况下滚筒的载荷谱;分析了采煤机截割阻力矩、截割功率随滚筒转速和牵引速度变化的规律。研究结果表明:截割硬质包裹体受到的载荷波动明显高于其他工况;滚筒转速越高,负载转矩相对于牵引速度的变化范围越小,截割功率沿滚筒转速和牵引速度增大方向不断上升。

关键词: 薄煤层采煤机, 载荷特性, 截割功率, 牵引调速

Abstract: In order to analysis the load characteristics of thin seam shearer drum under complex geological conditions, the determination conditions of tooth working state were proposed, the drum load calculation scheme was designed according to the condition of coal seam and the working state of shearer. A thin seam shearer drum as the object of research, the load spectrums of drum under five typical working conditions were calculated, the law of cutting resistance moment and cutting power with different drum revolution speed and haulage speed was analyzed. The results show that: the load fluctuation from cutting hard inclusions is significantly higher than other four conditions. Variation range of load torque respect to the change of haulage speed diminishes with the increase of drum revolution speed, cutting power along the drum revolution speed and haulage speed increases rising in both directions.

Key words: thin seam shearer, load characteristic, cutting power, speed regulation

中图分类号: